Cisco RV082 8-port 10/100 VPN Router Dual WAN Firmware

What's New:

1. The firmware supports RV082 v2 hardware and RV082 v1.x hardware. Note that

v2 hardware uses ADM6996I, whereas v1.x hardware uses ADM6996L.

2. The router is prevented from downgrading firmware from 2.x.x to 1.x.x on RV082

v2 hardware.

3. The administrative username can be configured on the Setup > Password page.

4. Fixed an issue with intermittent VPN connection.

5. Fixed an issue with logging unauthorized login attempts.

6. Fixed an issue with ProtectLink Gateway service caused by importing an old

configuration file, which was exported from firmware 1.1.6.14 or older.2

7. Fixed an issue with verifying the SSL certificate of the ProtectLink Gateway

license server.

8. Fixed a DHCP server issue, where not all DHCP clients in the LAN can get an IP

address.

9. Fixed a dual-WAN failover issue with SIP.

10.Fixed an issue with invalid Daylight Saving dates.

11. Fixed an issue with Split DNS over VPN.

12.The source port of DNS queries is now randomized by the NAT.

13.QuickVPN service will limit the maximum number of connection requests, as a

protection mechanism against Denial of Service (DoS) attack.

14.QuickVPN service will prevent brute-force password attack by a five-minute

timeout following five successive password errors within one minute.

15.SSLv2 is disabled for enhanced security.

16.The router will log a message when the ProtectLink URL queue is almost full,

warning users that URL blocking might occur if the URL Overflow Control in the

ProtectLink > Web Protection page is in the default setting. When the URL queue

returns to empty, the router will log a message indicating that the temporary

URL overflow has disappeared.

Known Issues:

1. QuickVPN Client v1.2.8 on Windows Vista cannot work properly when the Vista

PC uses a wireless adapter to connect to the network. The issue was fixed by

QuickVPN Client v1.2.11.

2. Windows Firewall needs to be enabled on Windows Vista in order for QuickVPN

Client to function properly. This is due to the fact that IPSec service on Vista is

disabled when Windows Firewall is disabled.

3. QuickVPN Client v1.2.6 on Vista does not work properly when the Server

Address is a DDNS domain name. This issue was fixed by QuickVPN Client

v1.2.8.

4. There is a known issue with Windows XP SP2 Firewall: ICMP packets are

always dropped by the Firewall when the Firewall is enabled. The issue will

prevent the QuickVPN Client from successfully establishing a tunnel with the

remote QuickVPN Server. Microsoft released a patch to fix this issue. After you

install the patch, the issue should be resolved. Visit the following URL:

http://support.microsoft.com/kb/889527/en-usRelease Notes for RV082 Firmware Version 2.0.0.19-tm 3

5. Port 60443 is a special port used for QuickVPN and cannot be used for remote

management. Similarly port 1723, which is used for PPTP, cannot be used for

remote management.